The top offset will default to the last used value e g.
Revit only shows 2 floors but the building has 3.
Orthographic views only adjust the position of the level head when the level is controlled by a scope box or a section box.
At the prompt click yes to have revit lt rename the corresponding views.
After creating a mass for a conceptual design create a mass floor at each level defined in the project.
Mass floors are based on levels defined in the project.
This isn t an underlay nor is it a transparent floor.
Verify the detail level for the category of the element.
That sounds like a nasty little endless loop.
If you are in a level 1 view and set the top offset to level 2 the next.
See override graphic display of element categories.
You are almost certainly going to want to change these default names to something more.
In the visibility graphic overrides dialog try the following.
If you are in the level 3 plan view then the base constraint will be set to level 3.
Architecture tabdatum panel level structure tabdatum panel level place the cursor in the drawing area and click.
You can select the mass in any type of project view including floor plan rcp elevation section and 3d views.
Which suggests perhaps a setting somewhere.
Click modify mass tabmodel panel mass.
Use the blue grip dot to drag the level head to the desired position.
Model categories can have detail level set independent of the view s detail level.
Alternatively you can rename levels by renaming the corresponding view in the project browser.
If i start a new project from the revit template i don t get this behavior.
Display a specific set of levels in the view and control their boundaries.
A level s name helps you to identify what that datum represents be it a floor level underside of steelwork etc etc.
As you place the cursor to create a level if the cursor aligns to an.
If you have not already done so add levels to the project.
Given some walls that go from level 1 to level 2 and a floor at level 2 i have a project where these walls below show thru the floors in plan.
In addition to creating a level for each story in a building you can also create reference levels such as sill level.
For name enter 00 foundation and click ok.
By default revit will name these new levels level 1 level 2 level 3 and so on.
Open the section or elevation view to add levels to.
On the ribbon click level.
Create a scope box and apply it to the view.
Just for future reference when placing walls revit will default the base constraint to the level of the view you are in.
